CONTA-CLIP EMS plotter drivers - Manual (Page 10)

www.conta-clip.com
4. Windows 2000
1. Sign in as an administrator. Open the Folder “Psetup” and start the program
“psetup.exe”
2. A message window will remind you to keep the plotter / engraver switched off. Click on
“OK” to start the pre- installation.
3. During the installation of the plotter / engraver software the message window
“Digital signature not found” appears.
Answer the question “Do you want to continue the installation?” with “Yes”.
4. When the pre- installation is finished, you will be notified that you can now connect and
switch on your plotting or engraving device. Acknowledge with “OK”.