CIRCUTOR AFQ Series - Manual (Page 26)

AFQ-4W
26 Instruction Manual
3.7.- CONNECTING THE FILTER TO THE MAINS
Once the connections specified in the above sections have been checked, the
main switch of the active filter will be switched on. When the unit is started, the
messages “NOT INITIAL CONDITIONS” and “Starting …” must appear on the
display ( Figure 20 ).
Figure 20: Start-up message of the AFQ-4W.
A few seconds later, the message “Set Up transformer ratio” will appear
( Figure 21 ).
Figure 21: Home screen displayed during the AFQ-4W's start-up.
Another message may appear if there is some problem in the filter connections
or the power supply. The section APPENDIX A: DISPLAY MESSAGES of this
manual describes all of the causes of malfunction and their corrective measures.