CIRCUTOR FRE Series - Manual (Page 6)

FRE / FRES
6 / 20
forks must be flat and laid firmly on the base. The cabinet must be raised by placing the forks underneath
the profile that supports the equipment. (Fig. 3-2).
There might be an offset in the centre of gravity from the centre of the cabinet, as a
result of the uneven distribution of loads in equipment. The necessary precautions
must be taken to prevent the equipment from tipping over during abrupt operations.
Fig. 3-2 .-Unloading with a Forklift
3.3 Storage
The following storage recommendations should be followed for static capacitor banks with detuned filters:
- Avoid placing it on uneven surfaces.
- Do not store in outdoor or humid areas or areas exposed to the splashing of water.
- Avoid hot zones for storage (maximum environmental temperature: 45 ºC)
- Avoid saline and corrosive environments.
- Avoid storing the equipment in areas where dust is generated or where the risk of chemical or
other types of contamination is present.
- Do not place heavy parcels or other equipment on top of the FRE or FRES cabinets.
4 TECHNICAL CHARACTERISTICS
4.1 Label with the equipment's characteristics
The label with the equipment's characteristics is located inside it, generally next to the PF regulator (refer
to Fig. 4-1). A capacitor bank with filters includes always the p% information, which states the filter's
tuning factor. This information is important to establish the filter's resonance frequency.
Fig. 4-1.- Label of characteristics