CIRCUTOR CVM-BD Series - Manual (Page 28)

-- Supply network analyzers CVM-BD-420-4 & CVM-BD-420-8 -- M98132301-20 --- Page Nº 27
c.- Scale offset
:
Value of the parameter that we assign as the zero of the scale.
dA 1 OUTPUT D/A No.1
Zero Zero of the scale:
x.xxx
allows choosing the zero of the scale
(four digits with floating decimal point)
- "max" key: it allows modifying the value of the blinking value.
Every time it is pressed the number is increased.
- "min" key: it allows validating the blinking value and go to the next digit.
NOTE : When you arrive at the last digit, you can move the position of the decimal
point with the "max" key.
- "display": to validate the selected option and pass to the next setup screen.
d.- Full scale: Value of the parameter to which we assign the 20 mA.
dA 1 OUTPUT D/A No.1
F.ESC Full scale:
x.xxx
allows choosing the full scale (20 mA)
(four digits with floating decimal point)
Proceed as in the previous section.
-
To access the next option, press "display": setup options for the rest of analog
outputs will appear up. Setup procedure is similar for any output.