BINDER MK 53 - Manual (Page 55)

MK (E2.1) 10/2014 page 55/73
With every decontamination method, always use adequate personal safety controls.
In case of contamination of the interior by biologically or chemically hazardous goods, there are two possi-
ble procedures depending on the type of contamination and charging material.
(1) Spray the inner chamber with an appropriate disinfectant.
Before start-up, the unit must be absolutely dry and ventilated, as explosive gases may form during
the decontamination process.
(2) If necessary, have strongly contaminated inner chamber parts removed by an engineer for cleaning,
or have them exchanged. Sterilize the inner chamber parts in a sterilizer or autoclave.
In case of eye contact, the disinfectant spray may cause eye damage due to chemical
burns. Follow the operating instructions and safety hints labeled on the bottle of the disin-
fectant spray.
Recommended precautions: To protect the eyes use sealed protective goggles.
CAUTION
Eye contact.
Eye damage due to chemical burns.
∅
Do NOT empty into drains.
 Wear protective goggles.
After using the disinfectant spray, allow the unit to dry thoroughly, and aerate it sufficiently.
15.3 Sending back the unit to the BINDER GmbH
If you send a BINDER product to us for repair or any other reason, we will only accept the product upon
presentation of an authorization number (RMA number) that has previously been issued to you. We will
issue an authorization number after receiving your complaint either in writing or by telephone prior to your
sending the BINDER product back to us. The authorization number will be issued following receipt of the
information mentioned below:
•
BINDER product type and serial number
• Date of purchase
• Name and address of the dealer from which you bought the BINDER product
• Exact description of defect or fault
• Your full address; if possible contact person and availability of that person
• Exact location of the BINDER product
• Contamination clearance certificate (chap. 19) via fax in advance
The authorization number needs to be applied to the packaging in such a way that it can be easily recog-
nized or be recorded clearly in the delivery documents.
For security reasons we cannot accept your delivery if it does not carry an authorization num-
ber.
Return address: BINDER GmbH
Abteilung Service Gänsäcker 16
78502 Tuttlingen, Germany