BINDER M 53 - Manual (Page 58)

M (E2) 10/2014 page 58/71
Unit size 53 115 240 400 720
Temperature data (continued)
Recovery time after door
was opened for 30 sec 2)
to 70 °C min 1 1 1 1 1
to 150 °C min 3 3 3 3 3
to 300 °C min 5 5 5 5 5
Air change (air flap open)
at 70 °C x/h 180 87 57 51 33
at 150 °C x/h 192 96 60 54 36
at 300 °C x/h 160 78 54 48 29
Electrical data
IP system of protection acc. to EN 60529
20 20 20 20 20
Nominal voltage (±10 %) 50/60 Hz V 230 1N~ 230 1N~ 230 1N~ 400 3N~ 400 3N~
Nominal power kW 1.20 1.60 2.70 3.40 5.00
Energy consumption 3)
at 70 °C Wh/h 145 230 370 520 570
at 150 °C Wh/h 300 544 850 1200 1320
at 300 °C Wh/h 720 1100 1400 2340 2600
Power plug
shock
proof plug
shock
proof plug
shock
proof plug
CEE plug
5 poles
CEE plug
5 poles
Installation category acc. to IEC 61010-1 II II II II II
Pollution degree acc. to IEC 61010-1 2 2 2 2 2
Legend:
1) Door without window
2) Up to 98 % of the set value
3) Use this value for sizing air condition systems.
All technical data is specified for unloaded units with standard equipment at an ambient temperature of
+25 °C / 77 °F and a power supply voltage fluctuation of ±10. The temperature data is determined in ac-
cordance to BINDER factory standard following DIN 12880, observing the recommended wall clearances
of 10 % of the height, width and depth of the inner chamber. Technical data refers to 100% fan speed.
All indications are average values, typical for units produced in series. We reserve the right to
change technical specifications at any time.
If the chamber is fully loaded, the specified heating up and cooling down times may vary ac-
cording to the load.