BINDER M 53 - Manual (Page 15)

M (E2) 10/2014 page 15/71
2.2 Control panel
Figure 4: Control panel for M with key switch (option)
(1) Green pilot lamp: ready for operation
(2) Main power switch ON/OFF
(3a) Red pilot lamp of the temperature safety device class 2
(3) Temperature safety device class 2
(4) Display program controller MB1
(5) Key switch (with option keyboard locking, chap. 11.10)
3. Completeness of delivery, transportation, storage, and installa-
tion
3.1 Unpacking, and checking equipment and completeness of delivery
After unpacking, please check the unit and its optional accessories, if any, based on the delivery receipt
for completeness and for transportation damage. Inform the carrier immediately if transportation damage
has occurred.
The final tests of the manufacturer may cause traces of the shelves on the inner surfaces. This has no
impact on the function and performance of the unit.
Please remove any transportation protection devices and adhesives in/on the unit and on the doors and
take out the operating manuals and accessory equipment.
CAUTION
Sliding or tilting of the unit.
Damage to the unit.
Risk of injury by lifting heavy loads.

Do NOT lift or transport the unit using either the door or the handle.
 Do NOT lift units size 400 and 720 by hand.
 Lift units size 53, 115 and 240 near the 4 unit feet from the pallet with the aid of 4 peo-
ple.
 Lift units size 400 and 720 using technical devices (fork lifter) from the pallet. Set the
fork lifter only from the rear in the middle of the unit. Make sure to place all the lateral
supports of the unit on the forks.
(4) (5) (3) (3a) (2) (1)