BINDER BD 23 - Manual (Page 20)

BD / ED / FD (E2) 02/2015 page 20/63
For disposal of the transport packing, see chap. 10.1.
Note on second-hand units (Ex-Demo-Units):
Second-hand units are units that have been used for a short time for tests or exhibitions. They are
thoroughly tested before resale. BINDER ensures that the chamber is technically sound and will work
flawlessly.
Second-hand units are marked with a sticker on the unit door. Please remove the sticker before
commissioning the unit.
3.2 Guidelines for safe lifting and transportation
The front castors of units size 720 can be blocked by brakes. Please move the units with castors only
when empty and on an even surface, otherwise the castors may be damaged. After operation please
observe the guidelines for temporarily decommissioning the unit (chap. 10.2).
CAUTION
Sliding or tilting of the unit.
Damage to the unit.
Risk of injury by lifting heavy loads.

Transport the unit only in its original packaging.
 Secure the unit with transport straps for transport.
∅ Do NOT lift or transport the unit using the door handle or the door.
∅ Do NOT lift units size 400 and 720 by hand.
 Lift unit size 23, 53, 115 at its four lower corners with the aid of 2 people, unit size
240 with the aid of 4 people, and place it on a transport pallet with wheels. Push the
pallet to the desired site and then lift the unit from the pallet at its four lower corners.
 Place units size 400 and 720 using technical devices (fork lifter) on the transport
pallet. Set the fork lifter only from the rear in the middle of the unit. Make sure to
place all the lateral supports of the unit on the forks.
 Transport units size 400 and 720 ONLY with the original transport pallet. Set the fork
lifter only to the pallet. Without the pallet the unit is in imminent danger of
overturning!!
• Permissible ambient temperature range during transport: -10 °C to +60 °C / 14 °F to 140 °F.
You can order transport packing and pallets for transportation purposes from BINDER Service.
3.3 Storage
Intermediate storage of the unit is possible in a closed and dry room. Observe the guidelines for
temporary decommissioning (chap. 10.2).
•
Permissible ambient temperature range during storage: -10 °C to +60 °C / 14 °F to 140 °F.
• Permissible ambient humidity: max. 70 % r.H., non-condensing
When after storage in a cold location you transfer the unit to its warmer installation site, condensation
may form. Before start-up, wait at least one hour until the unit has attained ambient temperature and is
completely dry.