1 first start-up, 1 selecting duct (left or right), 2 setting output channel – AXING SKP 2-00 User Manual

Page 9: 3 setting tv standard, 2 programming input channels via osd, First start-up, Programming input channels via osd

Programming

SKP 2-00

Page 9

4.1 First start-up

During initial operation of the SKP 2-00 one
must set first all output channels and the
relevant TV standard must be set!

4.1.1 Selecting duct (left or right)

To be able to program the left duct of the Twin
module, the programming selection switch
must be moved to the left.

After pressing the UHF key on the remote
control, a point lights up at the bottom right
corner of the display of the left duct.

This shows that the modulator is in
programming mode.

A test image and test sound are switched on.

4.1.2 Setting output channel

By pressing the CH

/ CH key, the desired

output channel may be set.

Special channels are labeled by a 2nd dot
between the digits on the display.

4.1.3 Setting TV standard

To set the TV standard, the SYS key (on the
remote control) must be pressed until the
desired TV standard is set.

These settings must be saved with the OK key.

To discard settings, press the EXIT key.
Programming mode is ended. Test image and
test sound are turned off.

After finishing the programming, the
programming selection switch must be moved
to the centre position.

Programming of the right duct is done
identically as for the left duct.

4.2 Programming input channels

via OSD

After programming the output channels of the
SKP 2-00, the starting window will be
displayed. A measuring device or a TV
receiver must be connected to the output of the
SKP 2-00 or the active output combiner and
must be aligned with the respective output
channel.

Fig. 7

Start window

Serial number and software version of the
respective twin module is displayed.

The set output channel is shown on the
Display.

Fig. 8

Preprogramming

As some channels are pre-programmed in the
modules, a pre-set channel is opened.
Information about SAT position, frequency,
symbol rate, FEC and VPID is shown. The
image of the channel is only visible, if the head
end is configured for this satellite.

If no pre-programming exists, the starting
window (see fig. 7 on page 9) is displayed
permanently.

If a CA module is used, it may take some time
to open an encoded program.

TV standard

Display

Tab. 1:

TV standards