AXING SKP 2-00 - Manual (Page 10)

Programming
SKP 2-00
© AXING AG – state of the art: 8.12.10 – Reserving change in design and type Page 10
4.3 On-Screen Programming
The module to be programmed can be
selected by means of the programming
selection switch.
The measuring device must be aligned to the
respective output channel. If a monitor is used,
it must be connected to the respective duct via
the AV-Cinch outputs of the module. (Cinch/
RCA cables or cinch/RCA to scart cables)
After pressing the menu key, the main menu
opens.
Fig. 9 Main menu
The desired menu item is selected by means of
the CH / CH key.
4.3.1 Channel list
Select the menu item “Channel list” and
confirm with OK. If a pre-programmed channel
list is included within the module, the following
selection appears.
Fig. 10 Channel list
On this list all pre-programmed channels
appear with the current position of the satellite
(A, B, C or D), transponder frequency, band
information, name of the channel as well as
program status (FTA/CA).
To be able to display encoded
(CA = Conditional Access) programs, an
appropriate CA module and a smart card must
be plugged in.
The desired receiving channel can be selected
using the CH /CH keys or by scrolling
using / .
After pressing the OK key, the channel is
applied, the menu closed and the image
displayed.
By pressing the EXIT key, the menu is closed
without accepting the receiving channel.
4.3.2 Info
Select menu item “Info” and confirm with OK.
The current software as well as the serial
number of the module are displayed.
Fig. 11 Info
Note
Note