3 installation and connection, Installation and connection, Installation and connection in a headend base unit – AXING SKP 2-00 User Manual
Page 6: 3installation and connection
Installation and connection
SKP 2-00
© AXING AG – state of the art: 31.5.12 – Reserving change in design and type
Page 6
3
Installation and connection
The SKP 2-00 can either be operated in a headend basic unit SKS x-xx or in stand alone mode. SAT IF
signals of the LNB(s) are either provided through optionally available input splitters or directly to SAT IF
inputs.
3.1 Installation and connection in a headend base unit
If the SKP 2-00 should operate in a headend basic unit SKS x-xx, the twin module is plugged in the output
collection field 1 and fastened with screws. Each free slot may be used. The power supply of the module
is provided by the output collection field.
Before inserting or changing a module, pull the mains plug of the headends basic unit from the socket!
Ground the base plate in order to avoid dangerous overvoltages according to EN 50083-1, EN 60728-
11:2010 (attention: risk of fire/death).
For detailed information on the headend base unit, refer to whose operating instructions.
Fig. 3
Installation and connection a headend base unit
1
base plate without modules
base plate fully equipped