AXING SKP 2-00 - Manual (Page 13)

Programming
SKP 2-00
© AXING AG – state of the art: 8.3.11 – Reserving change in design and type Page 13
Selection add submenu Add Default
Channels
The menu item is activated by pressing the OK
key. The program list stored in the factory is
reset.
Fig. 20 Add submenu programs
Finish configuration menu
To end the menu item, press the EXIT key.
4.3.4 Modulator
Fig. 21 Modulator
Select the menu item “Modulator” and confirm
with OK.
Fig. 22 Modulator menu
The desired output channel can be selected by
means of the VOL
/ VOL keys. This is also
shown in the display of SKP 2-00.
Selection submenu TV standard
The submenu is loaded by means of the CH
/CH keys.
The TV standard line is then displayed with
colored background.
The desired TV standard can be selected by
means of the VOL
/ VOL keys. In BG and
DK standard, additional audio settings can be
made. The audio signal is mono in all other
standards.
Selection submenu audio mode
After selecting the submenu audio mode by
means of the CH
/CH keys, you can
choose between mono and stereo in the BG or
DK standard.
All setting possibilities described above are
shown in the following image.
Fig. 23 Selection in the modulator menu
Selection submenu Output Level
After selecting the “Output Level” submenu by
means of the CH
/CH keys, the the
modulator can be changed in 1dB steps by
means of the VOL
/ VOL keys.
20 equals an output level of 105 dBµV. The
maximum level decrease is –20dB
(equals = 0).
Selection submenu precise adjustment
If the output channel does not correspond to
the CCIR pattern, the output frequency can be
changed and adjusted in steps of 250 kHz. The
adjustment range is +/- 4 MHz.
The setting is done by means of the VOL /
VOL keys.
Exit modulator menu
After pressing the EXIT key, the menu is
closed and all settings are saved.
4.3.5 Menu language
Fig. 24 Menu language