37 bluac5-si hardware manual, Accessories – Applied Motion BLuAC5-Si User Manual

Page 37

BLuAC5-Si Hardware Manual

920-0035E

12/10/2014

Accessories

Motor Cables for Applied Motion “A”, “N” and “M” series servo motors:

BLUMTR-FA-04, four foot shielded and filtered cable

BLUMTR-FA-10, ten foot shielded and filtered cable

BLUMTR-FA-20, twenty foot shielded and filtered cable

Motor Cables for Applied Motion “J” series servo motors:

3004-307-3M, nine foot shielded and filtered cable

Encoder Cables for Applied Motion “A”, “N” and “M” series servo motors:

BLUENC-CA-04, four foot shielded cable

BLUENC-CA-10, ten foot shielded cable

BLUENC-CA-20, twenty foot shielded cable

Encoder Cables for Applied Motion “J” series servo motors:

3004-301-3M, nine foot shielded cable

Breakout Box for IN/OUT Connectors:

BOB-1, for IN/OUT 1, includes cable

BOB-2, for IN/OUT 2, includes cable (sometimes known as “BABS” because it’s a female

version of the BOB-1)

Screw Terminal Connectors that mate directly to the IN/OUT connectors on the front panel of
the drive:

Phoenix Contact P/N

(for IN/OUT 1)

This connector is not available from Applied Motion. You must purchase it from a

Mating Cable for IN/OUT connectors with “flying leads”

Black Box P/N: BC00702

This cable is not available from Applied Motion. You must purchase it from

Useful for custom wired applications. This shielded cable has a DB-25 connector on each

end. If you cut it in half it will provide 3 foot “DB-25 to flying lead cables” for both IN/OUT1

and IN/OUT 2. It’ll be easier to wire if you get the

Surge Protector with Line Filter:

For 120VAC:

For 220VAC:

External Regen. Resistor Assembly
Specifically designed for the BLuAC5: RA-100 available from Applied Motion Products.