Optoma EH7700 - Manual (Page 15)

15
English
Installation
Powering Off the Projector
1. Press the “ ” button on the remote control or press the “
” button on the control panel to turn off the projector. 4
The following message will be displayed on the screen.
Press the “ ” button on the remote control or press the “
” button on the control panel again 4 to confirm otherwise
the message will disappear after 15 seconds. When you
pressing for the second time, the projector will shut down.
2. The cooling fans continue to operate for about 60 seconds
for cooling cycle and the POWER LED will flash Blue.
When the POWER LED turns red, the projector has
entered standby mode.
If you wish to turn the projector back on, you must wait
until the projector has completed the cooling cycle and
has entered standby mode. Once in standby mode, simply
press the “ ” button on the remote control or press the “ ”
button on the control panel to restart the projector. 4
3. Power off the switch. 2
4. Disconnect the power cord from the electrical outlet and
the projector.
5. Do not turn on the projector immediately following a power
off procedure.
12V OUT RS232
R G B H V
S-VIDEO VIDEO Y Pb Pr
HDMI 2 HDMI 1
VGA-OUT VGA 2-IN VGA 1-IN
WIRED
REMOTE-IN
SOURCE
INFO. MENU
SHUTTER
ENTER
RE-SYNC LENS
FOCUS
ZOOM
Or
4