Installing on red hat enterprise 5, Installing on red hat enterprise 5 -2 – Altera USB Blaster User Manual
Page 12
Installing on Red Hat Enterprise 4 or Earlier Versions
1. Add the following lines to the
/etc/hotplug/usb.usermap
file.
#
# Altera USB-Blaster
#
usbblaster 0x03 0x09fb 0x6001 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0
usbblaster 0x03 0x09fb 0x6002 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0
usbblaster 0x03 0x09fb 0x6003 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0
2. Create a file named
/etc/hotplug/usb/usbblaster
and add the following lines to it.
#!/bin/sh
# USB-Blaster hotplug script
# Allow any user to access the cable
chmod 666 $DEVICE
3. Make the file executable.
4. Complete your installation by setting up the programming hardware in the Quartus II software as
described in the following section.
Installing on Red Hat Enterprise 5
1. Create a file named
/etc/udev/rules.d/51-usbblaster.rules
and add the following lines to it. Ensure that all
code after
#USB-Blaster
must be in one line.
# USB-Blaster
BUS=="usb", SYSFS{idVendor}=="09fb", SYSFS{idProduct}=="6001", MODE="0666",
PROGRAM="/bin/sh -c 'K=%k; K=$${K#usbdev}; printf /proc/bus/usb/%%03i/%%03i $${K%%%
%.*} $${K#*.}'", RUN+="/bin/chmod 0666 %c"
2. Complete your installation by setting up the programming hardware in the Quartus II software.
Setting up the USB-Blaster Hardware in the Quartus II Software
1. Launch the Quartus II software.
2. Click Tools > Programmer.
3. Click Hardware Setup.
3-2
Installing on Red Hat Enterprise 4 or Earlier Versions
UG-USB81204
2015.05.04
Altera Corporation
Using the USB-Blaster Download Cable