Pilz PSSnet GW1 MOD-CAN - Manual (Page 15)

Safety
Operating Manual PSSnet GW1 MOD-CAN
1002693-EN-02
15
Warranty and liability
All claims to warranty and liability will be rendered invalid if
} The product was used contrary to the purpose for which it is intended
} Damage can be attributed to not having followed the guidelines in the manual
} Operating personnel are not suitably qualified
} Any type of modification has been made (e.g. exchanging components on the PCB
boards, soldering work etc.).
Disposal
When decommissioning, please comply with local regulations regarding the disposal of
electronic devices (e.g. Electrical and Electronic Equipment Act).
Safety during installation
The product requires a 24 VDC supply. Check that the external power supply provides this
voltage.
The tolerance of the supply voltage must comply with the technical details. Safe operation
cannot be guaranteed outside this range.
Protect the external power supply by fitting a fuse between the external power supply and
the product. The size of the fuse will depend on the specification of the external power sup-
ply, the conductor cross section and on local regulations.
WARNING!
Risk of electrocution!
Safe electrical isolation must be ensured for the external power supply that
generates the supply voltage. Failure to do so could result in electric shock.
The power supplies must comply with EN 60950-1:2006/A11:2009, EN
61558-2-6:11/1997.
WARNING!
Risk of electrocution!
When voltage is applied, contact with live components could result in seri-
ous or even fatal injury from an electric shock.
3.2.2
3.2.3
3.3