Uniden BCD396XT - Manual (Page 262)

262
Get/Set Band Scope System Settings
Controller → Radio
BSP[\r]
BSP,[FRQ],[STP],[SPN],[MAX_HOLD][\r]
Radio → Controller
BSP,[FRQ],[STP],[SPN],[MAX_HOLD][\r]
BSP,OK[\r]
[FRQ] : Center Frequency
[STP] : Search Step
500 : 5k 625 : 6.25k 750 : 7.5 k
833 : 8.33k 1000 : 10k 1250 : 12.5k
1500 : 15k 2000 : 20k 2500 : 25k
5000 : 50k 10000 : 100k
[SPN] : Sweep Span
0.2M, 0.4M, 0.6M,
0.8M, 1M, 2M,
4M, 6M, 8M,
10M, 20M, 40M,
60M, 80M, 100M,
120M, 140M, 160M,
180M, 200M, 250M,
300M, 350M, 400M,
450M, 500M
[MAX_HOLD] : Max Hold Display (0:OFF / 1:ON)
Get/Set Band Scope System Settings.
In set command, only "," parameters are not changed.
The set command is aborted if any format error is detected.
This command is only acceptable in Programming Mode.
Get Global IF exchange Frequency
Controller → Radio
GIE [\r]
Radio → Controller
GIE,[FRQ][\r]
GIE,-1[\r]
[FRQ] : IF Exchange Frequency (250000-13000000)
This command is used to get Global IF exchange frequency list.
You should call this command again and again to get all global IF exchange
frequencies until the scanner returns "-1".
"-1" means that no more IF exchange frequency exists.
This command is only acceptable in Programming Mode.