WebDT DT312/ DT362 Modules BOG (XPE/ XPPro) - Manual (Page 5)

WebDT Mobile Tablet Barcode Scanner Operation Guide
Mobile POS Tablet
Magnetic Stripe Reader
OPERATION GUIDE
www.dtresearch.com
Installation
The Magnetic Stripe Reader (MSR) is preinstalled as an option for
WebDT 312/ 362.
To Connect Magnetic Stripe Reader Module
To connect the Magnetic Stripe Reader, you can use the
WebDT Keyboard Wedge. Tap on the icon in the
task bar, a menu is displayed as shown in the picture
below. Choose Connect MSR.
To Configure MSR
For a magnetic stripe card, the raw data in each data track may contain start and end sentinel
characters. To remove those characters, you can select the Configure MSR command to parse input
raw data and filter out the start and end sentinel characters on each track.
Click Config MSR in the WebDT Keyboard Wedge menu, and the MSR Application 1.
Configuration window will be displayed.
Choose Enable in the Parse Data section. 2.
Choose data you want to parse at the start or
end of each track.
For Example:
Check Track 1
In Start Sentinel Character, select % •
In End Sentinel Character, select ? •
Click OK to complete the settings 3.