WebDT DT313H/DT315CT/ DT365/ DT395/ DT398B/ DT398C Modules BOG (Win7/ WES7) - Manual

www.dtresearch.com
Mobile POS Tablet
Barcode Scanner
www.dtresearch.com Scanner
DATA CAPTURE MODULE OPERATION GUIDE
To Connect Barcode Scanner Module
To connect the Barcode Scanner, you can use the Keyboard Wedge. Tap on the icon in the
task bar, a menu displays as shown in the picture below. Select Connect Scanner.
Scanner connected
To Test Barcode Scanner Module
Click 1. Start | All Programs | Accessories | NotePad to run the Notepad.
Scan one of the several supported barcodes. 2.
The output will appear in the Notepad screen.
Verify the captured data.
3.
The Default Port Parameters for Barcode Scanner Module
Port COM3
Baud Rate 115200
Data Bits 8
Parity None
Stop Bits 1
Flow Control None
Note: Please refer to Hyper Terminal Settings to confirm or change the port parameters.
SPECIFICATIONS
Scanning
Performance
Scan rate 60fps auto adaptive
Scan angle Tilt: 360°/ Pitch: ±45°/ Skew: ±65°
Optical resolution CMOS 844 X 640 pixels
Print contrast down to 20%
Note: Specifications are subject to change without notice.
Linear Imager Compliance and Precaution
This product complies with the following standards for laser and LED safety.
IEC 60825-1 Class2 LASER Product
signage dtri com
DT Research, Inc.
2000 Concourse Drive, San Jose, CA 95131 http://www.dtresearch.com
Copyright © 2015, DT Research, Inc. All Rights Reserved.