WebDT Wall/ Vehicle Mount Cradle - Manual

BASIC OPERATION GUIDE
Mobile Tablet
Wall/ Vehicle Mount Cradle
NOTE: To securely lock the Tablet into the cradle, lightly press on the Top Clasp until
the Slide-Lock Button can be pressed into the locked position.
INTRODUCTION
Thank you for acquiring the latest addition to DT Research’s line of tablet accessories – the
Mobile Tablet Wall/ Vehicle Mount Cradle. Featuring compact, robust ABS plastic, this
Cradle provides secure placement and charging of the Mobile Tablet whether mounted in
vehicles or on the wall. The innovative design promotes ergonomic and efficient access and
management of DT Research tablets.
Package Contents
• One (1) Mobile Tablet Wall/ Vehicle Mount Cradle
• One (1) VESA Conversion Bracket
• Four (4) silver Bushes for wall mounting
• Four (4) black Nuts for VESA mounting
• Eight (8) M4 Screws
signage dtri com
DT Research, Inc.
2000 Concourse Drive, San Jose, CA 95131 http://www.dtresearch.com
Copyright © 2013, DT Research, Inc. All Rights Reserved.
DT Research is a registered trademark of DT Research, Inc.
BOG0020315WMCENG
* NOTE: the cradle you receive may look slightly different than in this picture based on the exact model
ordered.
Releasing the Tablet Device from the Cradle
Press the Slide-Lock Button on the right side (hole in the center) until all the way pushed in
(left side Button will now be out).
1. Using two hands, hold the tablet on both sides, pull up on the tablet and top portion of
the cradle simultaneously until both stop.
2. Remove the Tablet from the Cradle.
3. NOTE: For proper operation, make sure all necessary connections are in place before
powering on the DT Research Mobile Tablet.
Locked
4
4. Press the Slide-Lock Button on the left
side of the cradle to lock the Top Clasp
and secure the Tablet. When locked, the
right side tab will stick out as shown.
After Before
Wall/ Vehicle Mount
Cradle for DT315/ DT365
Wall/ Vehicle Mount
Cradle for DT395
Wall/ Vehicle Mount
Cradle for DT311/
DT313/ DT398
Dimensions
(H x W x D)
10.2 x 7 x 2.6 in/
260 x 180 x 65 mm
9.1 x 7.5 x 2.6 in/
230 x 190 x 65 mm
10.8 x 7.7 x 2.6 in/
275 x 195 x 65 mm
Weight 1.72lbs/ 778g 2.08lbs/ 942g 1.96lbs/ 888g
I/O Ports
Ethernet RJ45 connector for
Ethernet x 1
RJ45 connector for
Ethernet x 1
RJ45 connector for
Ethernet x 1
DisplayPort N/A N/A 2
USB 2.0 2 2 2
DC-in 1. Input: 100 – 240V AC;
output: 12V DC, 3.5A
1. Input: 100 – 240V AC;
output: 19V DC, 6.31A
1. Input: 100 – 240V AC;
output: 19V DC, 6.31A
Phoenix 1 1 1
Specifications