Final check – Vortech 8-Rib Drive Upgrade for 2005-2009 Mustang GT User Manual

Page 15

P/N: 007084

15DEC08v1.1(007084v1.1)05MusMaxgrip

5. FINAL CHECK

A. Check all fittings, hose and clamps for tight-

ness and leaks. Make sure all wires and lines

are properly secure with clamps or tie wraps.

B. Make sure all wires and hoses are routed

away from hot, moving or sharp objects.

C. Double check to ensure water is flowing

through the CAC system. (If equipped.)

D. Test drive the vehicle.

Always listen carefully for engine detonation.

Discontinue heavy throttle usage if detonation

is heard.

WARNING: Do not attempt to operate the vehicle until ALL

components are installed and ALL operations are

completed including the final check.

• Custom ECM programming and fuel / ignition system

upgrades will be required when changing the super-

charger drive pulley to any size other than what was

originally supplied in the complete supercharger kit.

• A Vortech Maxflow Race or Mondo compressor bypass

valve is requires for applicaitons producing more than

11-12 psig.

NOTE: Check to see that CAC coolant is flowing

through the surge tank. If coolant is not flow-

ing, remove the 3/4" rubber hose from the side

of the surge tank and apply light suction in an

attempt to pass any trapped air in the system.

Reconnect the hose and recheck coolant flow.