Vortech 8-Rib Drive Upgrade for 2005-2009 Mustang GT - Manual (Page 13)

P/N: 007084
© 2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured.
15DEC08v1.1(007084v1.1)05MusMaxgrip
7
A. Non-Cooled Kits only:
Reinstall coolant overflow reservoir previously
removed using the factory hardware.
B. Reconnect the small overflow hose (running
across the top of the radiator) to the coolant
reservoir.
C. Reconnect the large hose at the bottom of
the coolant reservoir to the thermostat hous-
ing.
D. Check to make sure all previously installed
hose connections are secure using the previ-
ously removed hose clamps.
E. Fill the engine cooling system through the
coolant reservoir using the factory coolant
previously drained.
F. Locate the factory coolant reservoir cap and
install it on the reservoir.
G. CAC cooling system. (If equipped.)
1. Temporarily remove the 3/4" hose
attached to the 3/4" x 90° fitting.
2. Cap the open end of the 3/4" x 90° fitting.
3. Fill the CAC coolant using a 25%/75%
antifreeze/water mix. Fill through the 3/4"
hose removed from the surge tank fitting.
4. Fill the system until coolant level reaches
the surge tank.
5. Remove the cap from the surge tank fit-
ting and reinstall the 3/4" hose previously
removed and secure with the nylon ratch-
et clamp.
3. COOLANT RESERVOIR FILL