Charge air cooler tube installation – Vortech 2013 Scion FR-S and Subaru BRZ User Manual

Page 38

P/N: 4TF020-010 v2.1, 05/14/2013

NOTE: On Subaru BRZ models, the passenger

side headlight must be removed in order
to properly install the charge cooler tubes.

A. Locate the supplied discharge tube 'B'

(simple 90 degree bend) and slide a 2-1/2"
silicone sleeve and pair of #36 clamps on
each end of the tube. Attach the long leg of
the tube to the driver side of the CAC.
Temporarily snug the clamps so the tube
does not fall out, but can still be moved
slightly. See Fig. 7A.

B. Locate the supplied discharge tube 'A' (with

welded 1” boss attached). From the top,
slide discharge tube 'A' behind the left
(driver side) headlight and into the sleeve
on discharge tube 'B'. Attach discharge tube
'A' to the supercharger with the “bump”
sleeve and #36 clamp provided. See Fig. 7B.

C. Secure tube 'A' to the previously installed

airbox support bracket using the #36 clamp,
mount tab, M6 screw, washers and nuts. See
Fig. 7C.

Fig. 7A

Fig. 7B

7. CHARGE AIR COOLER TUBE

INSTALLATION

Fig. 7C