Vortech 2013 Scion FR-S and Subaru BRZ User Manual

Page 30

Text mode
Original mode

P/N: 4TF020-010 v2.1, 05/14/2013

K. With the slot mount at the bottom rear of the

charge-cooler, temporarily lift the charge-cooler
into place. Have an assistant pull down on the OEM
support to allow the cooler to fit in place. Place the
slot mount on the CAC over the support upper
flange. Replace the lower bolt on the support. See
Fig. 4M.

L. On the top, outboard corners of the charge-cooler

are the upper mounting brackets. Carefully position
the cooler so as to be centered, and parallel with
the A/C condenser, then adjust the upper mounting
brackets (they are slotted for adjustment).

M. Mark the holes to be drilled for the upper mounts

into the bottom of the OEM bumper beam. Reverse
the process with the center support and remove
the charge-cooler. Center-punch the marks and drill
four 3/16” mounting holes into the OEM bumper
beam.

Fig. 4M