Fig. 3j, Fig. 3i – Vortech 2013 Scion FR-S and Subaru BRZ User Manual

Page 20

P/N: 4TF020-010 v2.1, 05/14/2013

H. Check over the supercharger bracket assembly for loose

fasteners and fittings. One of the fasteners will remain
captured, but loose (see previous photo). Place the two of
the previously removed OEM idlers back into their former
positions (smooth pulley below the A/C compressor and
grooved pulley beneath the alternator) without the dust
washers or screws. Temporarily place the two main bracket
spacers with the new M10-1.25x90 fasteners through the
idler pullies and into the mounting bosses loosely.
Temporarily hold the supercharger/plate assembly in front
of the engine and familiarize yourself with the relative
placement of the components. Using the belt routing guide
graphic and photo as a guide, route the belt around the
accessory pulleys as shown, leaving slack for the
supercharger and its attached smooth idler pulley.
See Figs. 3I, 3J.

Fig. 3J

   

  

  















Fig. 3I