Vortech 2013 Scion FR-S and Subaru BRZ User Manual

Page 36

P/N: 4TF020-010 v2.1, 05/14/2013

G. Insert the OEM filler neck grommet into the

1.43” hole in the supplied tank. Ensure that it
is seated properly. Apply a very small
amount of white grease or similar lube onto
the inside diameter of the grommet. Insert
the non-beaded end of the supplied metal
tube into the grommet just far enough until
the end starts to push through the grommet
on the inside of the tank. See Fig. 6E.

H. Using the supplied M8 screws, nuts and

washers, install the new mounting brackets
to the reservoir. See Fig. 6F.

I. Insert the OEM washer pump grommet into

the 1.37” hole in the supplied tank cap.
Ensure that it is seated properly. Apply a
very small amount of white grease or similar
lube onto the inside diameter of the
grommet. Insert the OEM washer pump into
the grommet until seated. Install the cap/
pump assembly onto the tank. Ensure that
the cap gasket is in place and the cap is
snug. Rotate the pump and orient as shown.
See Fig. 6G.

Fig. 6E

Fig. 6F

Fig. 6G