Honda civic si, Installation instructions – Vortech 1999-2000 Honda Civic Si User Manual

Page 4

P/N: 4HC020-010

19JAN04 99-00Honda Civic Si(4HC v3.0)

P/N: 4HC020-010

19JAN04 99-00Honda Civic Si(4HC v3.0)

P/N: 4HC020-010

19JAN04 99-00Honda Civic Si(4HC v3.0)

P/N: 4HC020-010

19JAN04 99-00Honda Civic Si(4HC v3.0)

before beginning this installation, please read through this entire instruction booklet and the Street Supercharger

System Owner’s Manual which includes the Automotive Limited Warranties Program and the Warranty Registra-

tion form.
Vortech supercharger systems are performance improving devices. In most cases, increases in torque of 30-35%

and horsepower of 35-45% can be expected with the boost levels specified by Vortech Engineering. This product is

intended for use on healthy, well maintained engines. Installation on a worn-out or damaged engine is not recom-

mended and may result in failure of the engine as well as the supercharger. Vortech Engineering is not responsible

for engine damage.
Installation on new vehicles will not harm or adversely affect the break-in period so long as factory break-in pro-

cedures are followed.
For best performance and continued durability, please take note of the following key points:

1. Use only premium grade fuel 92 octane or higher (R+M/2).

2. The engine must have stock compression ratio.

3. If the engine has been modified in any way, check with Vortech prior to using this product.

4. Always listen for any sign of detonation (pinging) and discontinue hard use (no boost) until problem is

resolved.

5. Perform an oil and filter change upon completion of this installation and prior to test driving your vehicle.

Thereafter, always use a high grade SF rated engine oil or a high quality synthetic, and change the oil and

filter every 3,000 miles or less. Never attempt to extend the oil change interval beyond 3,000 miles, regard-

less of oil manufacturer’s claims as potential damage to the supercharger may result.

6. before beginning installation, replace all spark plugs that are older than 1 year or 10,000 miles with original

heat range plugs as specified by the manufacturer and retard timing from factory specifications (follow the

procedures indicated within the factory repair manual and/or as indicated on the factory underhood emis-

sions tag). Do not use platinum spark plugs unless they are original equipment. Change spark plugs every

at least 15,000 miles and spark plug wires at least every 50,000 miles.

TOOL & SUPPLY REQUIREMENTS:

• Factory Repair Manual

• 3/8” Socket and Drive Set: SAE & Metric

• 3/8” Swivel Head Ratchet

• 1/2” Socket and Drive Set: SAE & Metric

• 3/8” NPT Tap and Handle

• Adjustable Wrench

• Open End Wrenches: SAE & Metric

• Center Punch and a 5/8” Tapered Punch

• Springlock 5/16” Fuel Fitting Disconnect Tool

• 5 Quarts SH/CF Rated Quality Engine Oil

• Oil Filter and Wrench

• Flat #2 Screwdriver

• Phillips #2 Screwdriver

• Heavy Grease

• Silicone Sealer

• Drill Motor

• 1/8”, 3/16” Drill bits

• Hex Key Wrench Set

• Wire Strippers and Crimpers

• Utility Knife

If your vehicle has in excess of 10,000 miles since its last spark plug change, then you will also need:

• Spark Plug Socket

• New Spark Plugs

1999-2000

HONDA CIVIC Si

Installation Instructions

Congratulations on selecting the best performing and best backed automotive supercharger available today... the

VORTECH

Supercharger!