Radiator reservoir relocation, Power steering plumbing – Vortech 1999-2000 Honda Civic Si User Manual

Page 14

P/N: 4HC020-010

19JAN04 99-00Honda Civic Si(4HC v3.0)

P/N: 4HC020-010

19JAN04 99-00Honda Civic Si(4HC v3.0)

P/N: 4HC020-010

19JAN04 99-00Honda Civic Si(4HC v3.0)

P/N: 4HC020-010

19JAN04 99-00Honda Civic Si(4HC v3.0)

RADIATOR RESERVOIR RELOCATION

A. Remove the rear most top and bottom bolts from

the bracket holding the electrical plugs on the pas-

senger side strut tower.

B. Position the supplied bracket per Fig. 7-a and reinstall

the hardware.

C. Fit the reservoir to the bracket with the cap in-

stalled.

D. Run the supplied 5/16” hose from the radiator fill

neck to the radiator reservoir cap.

E. Remove the factory vent tube/water line assembly

from the valve cover breather. This assembly will

no longer be used.

F. Replace the hose running from the bottom of the

throttle body to the engine block with a piece of

the supplied 5/16” hose. Secure with the factory

clamps.

8. POWER STEERING PLUMbING

Fig. 7-a

Passenger strut tower as viewed

from the driver’s side of the vehicle

A. Lightly coat the O-ring on the supplied power steer-

ing pump fitting with Honda power steering fluid

and insert into the power steering pump. Rotate

fitting until the bolt holes line up with the pump.

Secure the fitting to the power steering pump using

the supplied 6mm bolts and washers.

B. Attach the straight fitting end of the supplied power

steering hose to the just installed power steering

pump fitting and tighten.

Fig. 8-a