Vortech 1999-2000 Honda Civic Si User Manual

Page 15

P/N: 4HC020-010

19JAN04 99-00Honda Civic Si(4HC v3.0)

P/N: 4HC020-010

19JAN04 99-00Honda Civic Si(4HC v3.0)

P/N: 4HC020-010

19JAN04 99-00Honda Civic Si(4HC v3.0)

P/N: 4HC020-010

19JAN04 99-00Honda Civic Si(4HC v3.0)

A. Remove the top four transmission-to-bell housing

bolts and the bracket that the ground strap is at-

tached to.

B. Remove the bracket and grommet securing the top

of the radiator to the vehicle. Install the supplied

bracket and original grommet in the original bracket.

(

See Fig. 10-a.)

C. Install the supplied 8mm stud with a .70” spacer in

the rear most hole.

D. Relocate the ground strap (minus bracket). The

ground strap may be refastened to the transmission

with one of the bracket bolts just removed if the hole

in the ground wire lug end terminal is opened up.

E. Remove the plastic drain fitting cap and install the

supplied 1/2” oil drain hose onto the barb fitting on

the bottom of the supercharger and secure with the

supplied #8 hose clamp.

10. SUPERCHARGER INSTALLATION

9. MAIN bRACKET INSTALLATION

A. Lower the supplied cast aluminum mounting bracket

assembly in front of the engine and push tightly

against the exhaust manifold. Lower the power

steering pump between the mounting bracket and

the vehicle frame.

B. Install the two shortest factory power steering bracket

bolts and the two supplied 10mm bolts in each of

the four mounting holes in the supplied mounting

bracket. Tighten to 33 ft/lbs (44 N-m). If necessary,

the A/C bracket can be lowered for bolt access.

C. Loosely install the power steering pump using the

original bolts and tensioner screw.

D. Install the supplied 2.25” idler pulley to the mount-

ing bracket. Make sure that the spacer between the

two idler pulley bearings slides over the mounting

bracket pilot, secure using the supplied 5/16 x 1- 1/4”

bolt and 5/16 washer (see Fig. 9-a).

Fig. 9-a

Fig. 9-b

NOTE: The lower radiator hose should be routed on

the engine side of the mounting plate.

Fig. 10-a