Ubiquiti Networks airFibe24 - Manual (Page 5)

2
Chapter 1: Overview airFiber ® AF24 User Guide
Ubiquiti Networks, Inc.
Back
Lock Bolts
Lock Bolts
Lock Bolts
Lock Bolts
Port Cover
Elevation
Adjustment Azimuth
Adjustment
Interfaces
Reset Data Aux Config LED Display
Interface Description
Reset
To reset to factory defaults, press and hold the Reset
button for more than five seconds while the unit is
already powered on.
Data 10/100/1000 Mbps port handles all user traffic.
Aux
Port for audio tone aiming. See “Using the Audio
Tone” on page 14 for more details.
LED Display
Digital display used for power, status, and mode
information.
Config
10/100 Mbps, secured port for configuration. By
default, this is the only port that can monitor,
configure, and/or update firmware.
LEDs
Link/Act
Speed GPS
Modulation Link/Act
Speed RX Power
Master/Slave RF Link Status
LED State Status
Data
Speed
Off 10/100 Mbps
On 1000 Mbps
Link/Act
Off No Ethernet Link
On Ethernet Link Established
Random Flashing Ethernet Activity
Au
x
GPS
Off No GPS Synchronization
On Operational (Strong Signal)
Normal Flash* Operational (Weak Signal)
Modulation
Off ¼x or 1x (QPSK SISO)
Short Flash* 2x (QPSK MIMO)
Normal Flash* 4x (16QAM MIMO)
Long Flash* 6x (64QAM MIMO)
LED Displa
y
RX Power
(-dBm)
Number Decodable RX Signal
Flashing Number Undecodable RX Signal
Overload Condition
Master/
Slave
Off Slave Mode
On Master Mode
RF Link
Status
Off RF Off
Short Flash* Syncing
Normal Flash* Beaconing
Long Flash* Registering
On Operational
C
onfig
Speed
Off 10 Mbps
On 100 Mbps
Link/Act
Off No Ethernet Link
On Ethernet Link Established
Random Flashing Ethernet Activity
* Short Flash (1:3 on/off cycle)
Normal Flash (1:1 on/off cycle)
Long Flash (3:1 on/off cycle)