Configure the data cable and com port, Software user manual – SurgeX EV-23010 User Manual
Page 5
Software User Manual
3. Configure the Data Interface Cable and COM Port
a. Click the COM Port Setup button labeled COM.
b. Click Configure.
i.
The auto configuration process will automatically set the correct device
parameters of the Data Interface Cable to operate properly with the
software and enVision.
•
Note: This process only needs to be done once for each new
Data Interface Cable installed on the PC.
•
Note: This process edits Windows registry values, and so may be
blocked by MS Windows User Account Control (UAC) in Windows
Vista/7/8. When using these operating systems, it may be
necessary to exit the software and restart it with administrative
rights by right-clicking the software shortcut and choosing “Run
As Administrator”.
© 2014 Electronic Systems Protection, Inc. /
Technical Support: 1-800-645-9721 /
espei.com
4