StorCase Technology 14-Bay 4U SCSI Ultra320 - Manual (Page 9)

4 Installation
StorCase Technology, Inc. InfoStation 14-Bay U320 Installation Guide - Rev. A00
Inserting a Drive into the Chassis
NOTES: A new drive can be inserted into an empty bay at anytime. However, the
drive will not be ready for access until the following procedure is
followed.
The key lock is only to prevent unauthorized removal or installation of the
drive carrier. Locking the key lock is not required for drive carrier
operation.
1. Press and hold the Insert/Remove button (Figure 2) in until the Drive Ready LED
starts to flash (approximately 3 seconds).
2. Drive is ready to be accessed when the Drive Ready LED glows instead of flashes.
Removing a Drive from the Chassis
(Refer to section "Drive Carrier Interface" in the InfoStation User's Guide for further infor-
mation)
NOTE: Proper procedure must be followed when removing a drive from the drive
bay. It is the responsibility of the User to ensure that the host does not
access the drive while attempting to remove the drive, and to follow the
procedure outlined below. Failure to do so may result in loss of data and/
or damage to the drive itself!
1. Press and hold the Insert/Remove button (Figure 2) in until the Drive Ready LED
starts to flash (approximately 3 seconds).
2. Drive is ready to be removed when the Drive Ready LED is OFF.
3. Unlock the key lock (if locked) and remove the drive carrier by pulling on carrier handle
(Figure 1).