StorCase Technology DE300i-S - Manual (Page 14)

Kingston Technology Company DE300i-S User's Guide - Rev. B00
8 Installation
Installation
1. Attach the I/O interface cable from the Data Express carrier board to the drive
(Figure 6).
2. Attach the four-pin power cable from the carrier board to the drive (Figure 6).
3. Install the appropriate three-pin ID select cable into the carrier board connector
(Figure 7). Refer to Figure 8 to decide which ID select cable to use. Figure 9
shows a typical drive with 2mm ID pins. Figure 10 shows a typical drive with
1.25mm ID pins.
4. Carefully insert the drive into the carrier at an angle, cable-end first. Make sure
that none of the cables are pinched. Lower the front of the drive carefully into
place. Fasten the drive into the carrier with four #6-32 x 3/16" F.H. screws
provided (Figure 6).
5. Attach the provided drive cover with two #6-32 x 3/16" F.H. screws (Figure 6).
Drive Carrier
Drive
Power Cable
I/O Interface
Cable/s
Drive Mounting
Screws (4ea)
Phillips # 6-32 x
3/16 Flat HD
ID Select Cable
(Typical)
0202
Protective
Drive
Cover
(Provided)
Drive Cover
Screws (2 plcs)
# 6-32 x 3/16
Flat HD
Figure 6: Drive Installation Assembly