StorCase Technology DE200i-SWC160 User Manual
Page 34
DE200i-SWC160 User's Guide - Rev. B01
StorCase Technology, Inc.
Appendix D - Field-Replacing the Carrier Fans
27
Fan
Bracket
Fan
0826
Phillips Head
Screws (4 per Fan)
1.
Carefully uninstall drive (if still installed in carrier). Refer to section
"DE200i-SWC160 INSTALLATION" for further information.
2.
To remove fan(s) to be replaced, loosen and remove the three (3) #6-32 Phillips
Flat Hd. screws securing the fan bracket to the drive carrier (Figure D-1).
3.
Carefully remove the fan bracket, making sure to disconnect the two (2) fan
power cables from the drive carrier.
4.
Remove the faulty fan(s) by removing the four (4) Phillips screws securing the
fan(s) to the fan bracket (Figure D-2).
5.
To install new fan(s), simply reverse above mentioned steps.
6.
Once fan(s) have been replaced, remove jumper on receiving frame motherboard
W1 Option Pin Connector - Pins 17 & 18 (if installed to temporarily disable the
Fan Fault LED and Alarm). Refer to section "Receiving Frame (Rear)" for
further information.
Figure D-2: Replacing the Fan