StorCase Technology DE200i-SWC160 User Manual

Page 13

Introduction

StorCase Technology, Inc.

DE200i-SWC160 User's Guide - Rev. B01

Fan Fault LED/Alarm Temporary Disable Jumper Option (Pins 17 & 18):

No Jumper (Factory Default) -

Fan Fault LED and Alarm will both function

when either fan fails.

Jumper on Pins 17 & 18-

Jumper (provided) installed will temporarily

disable both Fan Fault LED and Alarm in the

event of a single fan failure. Fan Fault LED

and Alarm will still function should the sec-

ond fan fail.

NOTE:

This jumper must be removed once the faulty fan is replaced! Refer to

Appendix D for further information.

 Enable Termination Power Connector (J4): This jumper is installed at the factory

and enables termination power to/from the SCSI bus.

NOTE:

Do not remove this jumper!

 Factory-Installed Jumpers (J3): There are two (2) jumpers factory-installed on J3.

One jumper is located on Pins 7 & 8, the other on Pins 9 & 10.

NOTE:

Do not remove jumpers! (Remove only if attaching the

DX1/200-SWC160/RH Isolator Board. Refer to Appendix B for further

information.)