StorCase Technology DE100i-SWC160 User Manual

Page 35

Appendix F - Differences Between Receiving Frame Revisions A00 and B00

StorCase Technology, Inc.

DE100i-SWC160 User's Guide - Rev. D01

DC Power

Connector

(P1)

J3 Jumpers

(Factory-Installed on

Pins 7 & 8 and Pins 9 & 10

Do Not Remove!)

68-Pin I/O

Connector

(J2)

Option Pin

Connector

(W1)

0456b

J4 Jumper

(Factory-Installed

Do Not Remove!)

Buzzer

FFAULT

BUZZ

Ground & Power Row

Reserved

Figure F-2: Rev. A00 Receiving Frame Motherboard

 Enable Termination Power Connector (J4): This jumper is installed at the factory

and enables termination power to/from the SCSI bus.

NOTE:

Do not remove this jumper!

 Factory-Installed Jumpers (J3): There are two (2) jumpers factory-installed on J3.

One jumper is located on Pins 7 & 8, the other on Pins 9 & 10.

NOTE:

Do not remove jumpers! (Remove only if attaching the

DX1/200- SWC160/RH Isolator Board. Refer to Appendix B for further

information.)