StorCase Technology DE100i-SWC160 User Manual

Page 34

DE100i-SWC160 User's Guide - Rev. D01

StorCase Technology, Inc.

Appendix F - Differences Between Receiving Frame Revisions A00 and B00

IIIIIIIIIIII IIIIIIIIIIII

xxxxxxx

Model Number: DE100i-SWC160

Interface Type: xxxxxxxxxxxxxxx

Serial Number:

CSA: xx xxxxx-xx

Rev: A00

0827

Revision Level

Figure F-1: Location of Data Express Receiving Frame Revision Level

If you have a Rev. A00 receiving frame, DO NOT refer to Figure 5, Figure 8, and Table

2 for pin assignments and information (as shown earlier in this User's Guide)! For

Rev. A00 receiving frames, refer to the following information for pin assignments

and information instead.

 DC Power Connector (P1): The DE100i-SWC160 uses a standard 4-pin DC power

connector to accept DC power.

 I/O Connector (J2) : The input/output connector provides a standard interface for

16-bit wide SCSI signals.

 Buzzer: Buzzer will sound in the case of a fan failure.

 Option Pin Connector (W1):

Remote Unit ID Selection: Pins 1-8 of this connector are provided for remote unit

SCSI ID selection through the computer system. Remote ID selection requires that the

unit ID switch located on the inside of the receiving frame be set to "0". (Onboard ID

selection is set with a switch located on the inside of the receiving frame as shown

in Figure 9). See Table F-1 for pin assignments.

FFAULT: Pins 17 & 18 enable Fan Failure LED (with factory-installed jumper).

BUZZ: Pins 21 & 22 enable Fan Failure Alarm/Buzzer (with factory-installed jumper).

Appendix F - Differences Between Receiving Frame
Revisions A00 and B00

All earlier information in this User's Guide applies specifically to DE100i-SWC160

receiving frames Rev. B00 and higher. If you are unsure of the Rev. level of your

receiving frame, refer to Figure F-1 below.