StorCase Technology DE100i-SWC160 - Manual (Page 14)

Installation 7
DE100i-SWC160 User's Guide - Rev. D01 StorCase Technology, Inc.
INSTALLATION
Installing the Drive in the Carrier
Preparation
While performing the steps in this section, work on a soft surface to prevent excessive shock
to the drive being installed. Also refer to the manufacturer's documentation provided with the
drive.
NOTE: A #2 Phillips screwdriver will be required during this procedure.
1. Remove the drive from its protective packaging.
2. Plastic Drive Bezel: If the drive came equipped with a plastic front bezel, it
must be removed.
3. SCSI Drive Termination: The DE100i-SWC160 does not provide onboard
termination. External termination must be provided. Refer to the documentation
provided by the drive manufacturer for termination information.
Installation
1. Carefully insert the drive into the carrier. Slide the drive towards the Drive Carrier
Board, so that the I/O connector on the drive mates with the I/O connector on
the board (Figure 6).
2. Fasten the drive into place with four (4) #6-32 Phillips Flat Hd. screws (Figure
6).
3. Once the drive is installed into the carrier, install the drive cover onto the carrier.
Fasten the cover into place with two (2) #6-32 Phillips Flat Hd. screws (Figure
7).
NOTE: Installation of drive cover is necessary for proper fan air flow!