Rocktron Utopia B300 - Manual (Page 69)

69
Step 10
Step 11
To make changes to the second Pedal Controller turn the PARAMETER SELECT
knob clockwise one click.
Repeat steps 3-10 to make changes to NUMB 2, PARA 2, ULIM C2, LLIM C2,
NUMB 3, PARA3, ULIM C3, LLIM C3.
Selecting a lower limit value that is greater than the upper limit value will invert the response of
the controller - i.e. the toe position of the expression controller will provide the minimum value,
while the heel position will provide the maximum value.
You now must store your changes. If you have made any changes to any parameter, the LED
above the "STORE" button will light. Press the STORE button to save the changes you have
made. "STORE AT PRESET" will flash intermittently with the current preset. If you would
like to save this change to the current preset, press the STORE button again. To save this ad-
justed preset (and the parameters you have just changed) to a different preset location, use the
PRESET SELECT knob to choose the preset and then press the STORE button again. Note
that doing this will "over-write" the preset you are saving to.
NOTE: To exit Pedal Controllers at any time or cancel any changes you have made, turn
either the PRESET or FUNCTION SELECT knob. The word CANCEL will flash on the display
and then return you to the preset you were working on..
Step 12
8. Pedal Controllers......continued.............
p e d a l c o n t r o l e r s
n u m b 2 I P E d
b 0 4 D I R T Y - c h o r u s
S T O R E A T P R E S E T
b 0 4 C U R R Y D I N N E R
4 2 f l a - D L Y - R E V
b 0 4 C U R R Y D I N N E R
C a n c e l
B 0 4 C U R R Y D I N N E R
4 2 f l a - D L Y - R E V