Rocktron Utopia B300 User Manual
Page 56

56
8. Operation Mode
The Utopia B300 has two OPERATION MODES - Preset and 2nd. When in Preset mode you can
select any preset you would like in the various banks. When in 2nd Mode you are in the 2nd function
mode of the selected preset. The 2nd Function mode allows you to turn on and off various aspects of
the preset.
In the PRESET MODE the LEDs on the pedal board will be lit "GREEN".
When in this mode you can select any preset in any bank that you would prefer.
PRESET MODE
2ND FUNCTION
MODE
To enter into the 2ND FUNCTION MODE, press the already selected preset a
second time. The LEDs on the pedal board will turn "YELLOW" with the 2ND
CANCEL button number 9 LED will be lit "RED". Once in the 2ND FUNC-
TION MODE you can turn on and off various effects within the selected presets.
Here is a list of those effects that can be accessed within each preset in the 2ND
FUNCTION MODE:
0
1
2
3
4
5
6
7
8
9
REVERB - turns on and off the reverb within the preset.
DELAY - turns on and off the delay within the preset.
MOD - turns on and off the modulation effect (chorus, flanger, pitch shift or
tremolo within the preset.
MUTE/TUNER - pressing this button will MUTE the output and turn on the
built-in Tuner so that you can tune in silence.
TAP - this button allows you to set the delay rates by tapping this button at the
tempo desired.
EFFECT BYPASS - turns on or off all the effects and bypasses them complete-
ly.
CHANNEL TOGGLE - allows you to toggle between two different channels
(for example, between DEEP and DIST)
EFFECT ON/OFF - turns on the assigned effect to that footswitch, either Com-
pressor, Solo or Tru-Bypass (this must be set and stored in the Footswitch Map-
ping Function).
Note: At anytime while in 2nd Mode any changes to the ON/OFF states of the
switches may be saved into the current preset being used. This adds flexibility
when setting preset effect(s) ON/OFF recall states within a preset.
EFFECTS LOOP I/O - turns on or off the effects loop
2ND CANCEL - pressing this button allows you to exit the 2ND FUNCTION
MODE and return to PRESET MODE
BUTTON NUMBER 2ND FUNCTION