PRW 14 PQ Series High Performance Aluminum Water Pump User Manual
Page 2
Page 2 of 2
Step 19 - Reinstall the belts and adjust them using a tension gauge. Refer to OEM specifications for
proper tension or adjust the belts to a deflection of ½” to ¾”. Inspect for any defects on the automatic
tensioner or idler pulley. Automatic tensioners will normally tighten with use.
Step 20 - Reconnect battery.
Step 21 - Start the engine and let it run until it reaches normal operating temperature. Check for any leaks
and make sure it is running smoothly.
Step 22 - Turn off the engine and re-check for leaks.
Possible Causes for Water Pumps Damage or Premature Wear
1. Dirty or corrosive coolant.
2. Defective, bent, or unbalanced fan.
3. Fan not squarely mounted on the shaft.
4. Defective or unbalanced clutch.
5. Cracked or bent pulleys due to improper handling or installation.
6. Loose or over tightened belts.
7. Fan shroud and radiator interference.
8. Loose or broken motor mounts.
9. Striking the bearing shaft on its end.
These installation instructions are general installation instructions for most water pumps. If you need
application specific instructions, please visit our website at
and go to the Tech Info
section.
PRW Industries, Inc.
1722 Illinois Avenue
Perris, California 92571
Tele: (951) 436-7900 FAX: (951) 928-8555
Tech: (888) 377-9779
www.prw-usa.com
LIMITATION OF WARRANTY
SELLER (PRW) hereby p
rovides the following limited warranty as to description, quality, merchantability, fitness for any product’s purpose,
productiveness, or any other matter related to the SELLER's product sold herewith. The SELLER shall not be responsible for t
he product’s
open use and/or service. The BUYER hereby waives all rights other than those expressly written herein. This Warranty shall not be extended
or varied except by a written agreement signed by SELLER and BUYER.
The Warranty is Limited to manufacturers defects for a period of one (1) year from the date of sale and restricted solely to the parts contained
within the product's kit. Any products in question of Warranty require a Return Manufacturers Authorization for inspection. Product must be
shipped prepaid to the SELLER and accompanied by a dated receipt or invoice and proof of purchase. All Warranty claims are subject to
approval by PRW Industries, Inc.
Under no circumstances shall the SELLER be liable for any labor, travel time, or other expenses incurred in the diagnosis of defects, removal, or
reinstallation of this product, or any other contingent expenses. Under no circumstances shall the SELLER be liable for any damage or
expenses incurred by reason of the use or sale of any such equipment. Other limitations may apply.
IN THE EVENT THAT THE BUYER DOES NOT AGREE WITH THIS POLICY: THE BUYER MAY RETURN THIS PRODUCT, IN NEW AND
UNUSED CONDITION TO THE PLACE OF PURCHASE. DATED PROOF OF PURCHASE IS REQUIRED WITHIN THIRTY (30) DAYS FROM
ORIGINAL DATE OF PURCHASE TO OBTAIN A FULL REFUND. THE INSTALLATION OF THIS PRODUCT INDICATES THAT THE BUYER
HAS READ AND UNDERSTANDS THIS AGREEMENT AND ACCEPTS THE TERMS AND CONDITIONS STATED.