PRW 33 PQ Series Aluminum Mopar Shaft Mount Rocker - Manual

PRW Industries, Inc.
1722 Illinois Avenue
Perris, California 92571
Tele: (951) 436-7900
Tech: (888) 377-9779
Installation instructions for prw aluminum
mopar rocker arms
PARTS LIST
Item Quantity
Aluminum Rocker Arms 16 each
Hardened Shafts 2 each
Ball End Adusters 16 each
Long Hold Down Bolts 4 each
Short Hold Down Bolts 6 each
Thin Spacers 16 each
Thick Spacers 8 each
Shim Kit 48 pcs
Large Hold Down Spacers 4 each
Small Hold Down Spacers 6 each
Extreme Pressure Lube #3 1 ¼ oz tube
NOTE: PRW Aluminum Mopar Rocker Arm part numbers 0331801, 0331802, 0331803, 0331804,
0344001, 0344002, 0344003, 0344011, 0344012, and 0344013 are designed exclusively for 5/16” ball
end adjusters and cup end pushrods.
Quick Tips
1. All pushrods in a set do not wear evenly or uniformly. Over time each will wear in a unique
fashion as it “mates” with the individual rocker arm that it is paired with. Consequently, old
pushrods should be replaced when new rocker arms are installed.
2. Make sure rocker arms and other components are well lubricated. Proper lubrication of all parts
can help prevent premature wear and/or permanent damage.
3. Check for any interference between rockers and valve covers.
4. Always use hardened shafts. Stock or unhardened shafts will result in premature wear and rocker
arm failure.
5. Make sure oil holes on shafts are facing down.
Installation
Step 1
After removing the rockers and other components from the package thoroughly wash each piece, and then
blow dry.
Step 2
Totally submerge the rockers in engine oil for approximately 30 minutes prior to installation to insure the
needle bearings are lubricated.