beautypg.com

PRW 32 PQ Series Alloy Steel Mopar Shaft Mount Rocker User Manual

Parts list item quantity

background image

PRW Industries, Inc.

1722 Illinois Avenue

Perris, California 92571

Tele: (951) 436-7900

Tech: (888) 377-9779

Installation Instructions For PRW Stainless

Steel Mopar Rocker Arms

PARTS LIST

Item

Quantity

Rocker Arms

16 each

Hardened Shafts

2 each

Cup End Adjusters

16 each

Hold Down Studs Big Block: 6 Short, 4 Long

10 each

Hold Down Studs Small Block: 10 Short

10 each

Thin Spacers

16 each

Thick Spacers

8 each

Shim Kit

48 pcs

Large Hold Downs

4 each

Small Hold Downs

6 each

Extreme Pressure Lube #3

1 1/4oz tube



Quick Tips
1. All pushrods in a set do not wear evenly or uniformly. Over time each will wear in a unique fashion as it
“mates” with the individual rocker arm that it is paired with. Consequently, old pushrods should be replaced
when new rocker arms are installed.

2. Make sure rocker arms and other components are well lubricated. Proper lubrication of all parts can help
prevent premature wear and/or permanent damage.

3. Check for any interference between rockers and valve covers.

4. Always use hardened shafts. Stock or unhardened shafts will result in premature wear and rocker arm
failure.

5. Make sure oil holes on shafts are facing down.

Installation

Step 1
After removing the rockers and other components from the package thoroughly wash each piece, and then
blow dry.

Step 2
Totally submerge the rockers in engine oil for approximately 30 minutes prior to installation to insure the
needle bearings are lubricated.