PRW 16 PQ Series Billet Steel Flywheel - Manual

For tech help, contact:
PRW
Toll Free (888) 377-9779
PQ Series SFI Billet Steel Flywheel
Installation Instructions
Each Box Contains:
♦ 1 Flywheel
♦ 1 SFI 1.1 Certification Sticker
Step 1
Be sure to make use of latex or other gloves as a protective measure. Use a rag to remove any residual oil and/or
cosmoline from the flywheel surfaces. Remove any machining burrs or debris from the threaded holes and
counterbores.
Step 2
Verify that the serial # on the SFI 1.1 sticker matches the engraved SFI number on the flywheel.
Step 3
Check the transmission and engine seals to insure that they are leak free. Replace any damaged seals.
Step 4
Be sure to completely remove any rust preventive additives from both the flywheel and pressure plate.
Step 5
Clean any burrs, rust, or other deposits from the crankshaft flange and flywheel.
Step 6
Place the flywheel in the clutch housing so that the dowel pin of the crankshaft enters the flywheel and centers it.
Step 7
Cover the flywheel bolts in Loctite®.
Step 8
Torque the flywheel bolts in a crossing pattern using the manufactures specifications. Follow the torque pattern below.
Do not us an impact wrench to mount the flywheel to the crankshaft. Using an impact wrench and/or failure to use the
manufactures recommended torque specification may damage the flywheel and/or other components and will void the
warranty.
Step 9
Place a dial indicator on the clutch housing, mounting it so the button of the indicator makes contact with the
machined surface of the flywheel. Now hand - turn the crank to check for run - out. There should be no more than
0.008”. If the run - out is excessive take the flywheel off and begin the process again, starting at step 4.
Starter Alignment and Shimming