Cleaning or replacing the wick, Adjusting wetness, Printer maintenance – Pitney Bowes DM875 Series User Manual
Page 167: Printer maintenance -7
DM825™ and DM875™ Series Digital Mailing System Operating Guide
SV62200 Rev. C
9 - 7
Cleaning or
Replacing the
Wick
1. Open the feed cover and lift the E-Z Seal® Sealing Solution bottle out
of its holder.
2. Remove the Moistener Brush Assembly as described in the Cleaning or
Replacing the Moistener Brush procedure.
3. Use your index and middle finger to remove the wick.
4. Clean the wick by holding it under running water.
5. Slide the wick back into place.
6. Replace the E-Z Seal® bottle.
Adjusting
Wetness
Adjust the wetness to increase of decrease the amount of fluid moved into
the sealer.
1. Press the Seal key.
2. Press the Adjust Wetness screen key. The Select Sealer Wetness
screen appears.
•
Press the left arrow key to decrease the wetness.
•
Press the right arrow key to increase the wetness.
3. Press Enter when done.
Printer
Maintenance
The printer components, consisting of the printer nozzle, ink cartridge and
printhead, require minimum maintenance to ensure clean, clear meter
imprints on your mail.
If the print quality deteriorates and you cannot improve it with the proce-
dures in this chapter, contact the Pitney Bowes Help Desk. Refer to the
Pitney Bowes Contact Information List at the front of this guide for the
phone number.
Wick