Pitney Bowes DM875 Series User Manual
Page 16
1 • Read This First
1 - 6
SV62200 Rev. C
ble. Failure to properly ground the machine can result in severe
personal injury and/or fire.
•
Avoid touching moving parts or materials while the machine is in use.
Keep hands, loose clothing, jewelry and long hair away from all moving
parts.
•
Do not remove covers. Covers enclose hazardous parts that should
only be accessed by properly trained service personnel. Immediately
report to Pitney Bowes Service any damaged or non-functioning com-
ponents that renders the unit unsafe.
•
Place the unit in an accessible location to allow for proper venting of the
equipment and to facilitate servicing.
•
The power cord wall plug is the primary means of disconnecting the
machine from the AC supply.
•
Do not use an adapter plug on the line cord or wall outlet.
•
Do not remove the ground pin from the line cord.
•
Avoid using wall outlets that are controlled by wall switches, or shared
with other equipment.
•
Do not route the power cord over sharp edges or trapped between fur-
niture.
•
Ensure there is no strain on the power cord where it becomes jammed
between the equipment, walls or furniture.
•
Be certain the area in front of the wall receptacle into which the
machine is plugged is free from obstruction.
•
To prevent overheating, do not cover the vent openings.
•
Read all instructions before attempting to operate the equipment.
•
Use this equipment only for its intended purpose.
If your stacker has an AC adapter to power the stacker:
•
Use only the AC adapter designed specifically for the stacker and
shown in Chapter 11, Supplies and Options. Third-party AC adapters
may damage the stacker.
•
To protect against electrical shock, plug the AC adapter power cord into
a properly grounded wall outlet.
Do not route the AC adapter cable over sharp edges or trap it between
furniture.
NOTE: Always follow the specific occupational safety and health standards
for your workplace.