PermaGreen Triumph Spread-Only - Manual (Page 32)

Sprayer Operation and Calibration 28
Spot Sprayer Operation
The Spreader Sprayer includes a hand-carried and hand-operated
bottle used to apply spray in areas that the Spreader Sprayer
cannot reach. When not in use, the Spot Sprayer is carried in a
machine-mounted bracket. Triumph provides room for an optional
second Spot Sprayer. The Spot Sprayer holds enough spray to
cover approximately 500 ft 2 (46.5 meters 2 ). [If the Half Gallon
Nozzle Kit is installed and refilled from the Spreader Sprayer, it
holds 250 ft 2 (23.25 meters 2 )]. The machine includes a Fill Valve for
refilling the bottle from the Spray Tank.
Applying the Spray.
Plan the spray application pattern required to cover the manual
application area.
IMPORTANT: Use caution when spraying near desirable
vegetation or painted surfaces to avoid damage.
IMPORTANT: Use caution when spraying in windy conditions
to avoid damage.
 To spray, invert the spray bottle and squeeze the bottle with
enough pressure to create the spray pattern needed.
 To stop spraying, stop squeezing and right the bottle.
Filling the Spot Sprayer.
The spray bottle can be filled directly from the Triumph spray
system using the Fill Valve.
 Park Triumph on level ground, shift into NEUTRAL, lock both
brakes, open Fill Valve, remove the cap, center the Spot
Sprayer under the Fill Valve, Throttle up the engine, and
dispense the spray mix into the spray bottle.
 When filled release Throttle, close Fill Valve, and install the
spray bottle cap.
Cleanup After Use
 Rinse the Nozzle, Nozzle strainer, cap, and spray components
in water.
 Inspect the components for wear and damage before
reassembly. Replace damaged and worn components.
 Dispose of spray and cleanup water according to the product
label and material safety data sheet.