PermaGreen Triumph Spread-Only - Manual (Page 10)

K) WARNING (DUPLICATE LABEL ON FRONT HOOD)
Exposed moving parts can cause severe injury. DO NOT start
engine or operate machine without guards in place.
L) WARNING
PINCH POINT! Keep hands and feet away
M) WARNING
AVOID SLIPPING INJURY. Stand only on footpads;
Replace worn footpads; Keep footpads clean.
N) WARNING
AVOID TRIPPING INJURY. Keep a firm grip on both
handles. Drop handlebars if necessary. Use caution stepping
on and off.
O) Serial Number Plate
P) WARNING
Tip-over, rollover or loss-of- control may cause death or
serious injury. This machine has a high center of gravity and
turf conditions affect stability. DO NOT operate on slopes
where traction and stability are doubtful. To help avoid tip-over,
rollover and loss-of-control, use extreme caution on hillsides
and:
• Study terrain and plan a safe operating pattern.
• DO NOT operate on slopes over 15 DEGREES.
• Use LOW GEAR on hills and lean uphill for balance.
• Avoid traveling straight down hill. Instead, zigzag down using
brakes to slow descent.
• Travel across the grade, beginning at the bottom and work
your way up.
• Avoid sharp turns and sudden starts and stops.
• Apply rear brakes first and then front brakes.
• Reduce the amount of granular and liquid products carried.
• Operate as a walk-behind in situations where tip-over,
rollover or loss-of-control is possible.
Machine Information Labels
FIGURE 2, Rear Labels
Machine WARNING Labels
(Refer to FIGURE 2)
SAFETY MANUAL 6
Q) WARNING
Improper operation and improper maintenance of this machine
may cause death or serious injury. DO NOT operate the
machine if:
• Engine speed exceeds 3,450 RPM.
• Machine moves unexpectedly when starting or shifting into
gear.
• You detect any unusual noise or vibration.
• You are underage or under the Influence of drugs or alcohol.
• Conditions are wet or there is low light.
• A passenger is on board. Inspect the work area and identify all
hazards present first. Stay clear of drop-offs, holes, debris or
other hazards. Before shifting gears, stop and then shift. Before
leaving the operator position, park on level ground, lock brakes,
shut off the engine, and shift into NEUTRAL. Perform daily and
weekly maintenance. Refer to the Operator Manual for details.
R) WARNING
Operation by an untrained person may cause death or serious
injury to the operator or others. DO NOT operate until you have
read and understand the Operator Manual and Safety
Information. DO NOT operate until you receive and understand
the following training:
• Machine Safety Labels.
• Operator controls.
• Safety Devices.
• Supervised Driver’s Training with enough practice time so you
can safely control the machine on hills.
• Pesticide handling safety.
• Fuel handling safety. The owner of this machine is responsible
for training operators and mechanics. If you cannot read English,
the owner must explain the material to you. The Operator
Manual is part of this machine and MUST be available to the
operator and mechanics at all times.
S) Shift Pattern
T) WARNING
DO NOT operate on slopes over 15 DEGREES. You
instinctively stand at your balance point (BP). When your BP is
outside the BALANCE ZONE, the slope is over 15⁰.
*Illustrations show operator on 15⁰ slopes.
U) WARNING
To avoid pesticide injury: Read and follow all handling
application and disposal precautions on the pesticide label;
Wear all the personal protective equipment required on the
label when handling and applying.
FIGURE 3, Panel Labels
Machine WARNING Labels
(Refer to FIGURE 3)
Machine Information Labels