Parr Instrument Series 4558 - Manual (Page 11)

4555 - 58 Series
5G & 10L Pressure Reactors
- 10 -
Fixed Head Vessel
Caution Symbols:
1. For the apparatus to be fully stable in all
configurations, the base of this unit must be securely
fastened to the floor before operation. Four 3-hole inside
corner brackets are provided (3159HC). Brackets will
accommodate 5/16” diameter anchoring hardware (not
provided). See drawing A3130HC Basic Main Support
Frame Pkg. shown in Appendix B.
2. See drawing A3140HC Pneumatic Vertical Lift Pkg in
the appendix. Moving parts, potential pinch-point. Keep
hands clear.
3. See drawing A3170HC 2 Hinged Split Ring Pkg in the appendix. Moving parts, potential
pinch-point. Keep hands clear.
Setting up the stand.
1. If the motor has been removed for shipping purposes, reinstall the motor. Refer to
drawings A3160HC and A3160HC2 (pages 43-45).
2. Unpack vessel assembly, remove the split rings, and lift the head assembly from the
cylinder.
3. If furnished with band heaters, install prior to mounting the cylinder.
4. Set cylinder mounting pad on the cylinder support plate. Refer to drawing A3150HC in
the appendix.
5. Handles are provided to assist in lifting the cylinder. Lift the cylinder and place it on the
cylinder support plate, lining up the holes for the retaining bolts. Install retaining bolts. Refer
to drawing A3150HC in the appendix.
6. Set the head assembly on the cylinder carefully to avoid damage to the sealing
surfaces.
7. Push in the cylinder support plate. Install 3 fixed head support rods (3156HC). Refer
to drawing 4557 Sheet 2 in the appendix.