Parr Instrument 6750 - Manual (Page 31)

Proximate Interface
P a r r I n s t r u m e n t C o m p a n y 30
Sartorius Balance Interface (Continued)
The interface will send this command string
once after the PROCEED key has been pressed
during a mass entry sequence. The PROCEED key
should only be pressed when the mass reading is
stable. However, unstable readings will be rejected
and a warning will be issued. Acknowledging the
warning by pressing the CLEAR ENTRY key will re-
start the mass entry process all over again.
A&D Standard Format (type 0)
Field Length
header 2
comma 1
data 9
units 3
CR 1
LF 1
The header fi eld must contain “ST” to indicate
stable mass. The data fi eld contains the current
mass, with leading zeros, and a decimal point.
Generic Interface
Field Length
data 2
CR 1
The data fi eld should consist of 8 numeric char-
acters (0 through 9,+,- and space) terminated with a
carriage return (CR).
Leading zeros may be blanked as spaces and are
counted. Non-numeric characters are ignored and
will reset the input buffer if the data fi eld has not
been fi lled. Any characters received after fi lling the
data fi eld and before the carriage return are ignored.
Parr Balance Interface Cables
Part # Description
A1880E 9 pin DS to 25 pin DP S-T
A1881E 9 pin DS to 25 pin DP Null
A1882E 9 pin DS to 25 pin DS S-T
A1883E 9 pin DS to 25 pin DS Null
A1884E 9 pin DS to 9 pin DP S-T
A1885E 9 pin DS to 9 pin DP Null
A1886E 9 pin DS to 9 pin DS S-T
A1887E 9 pin DS to 9 pin DS Null
2203E USB to Serial Adapter
Technical Service
Should you need assistance in the operation or
service of your instrument, please contact the Tech-
nical Service Department.
Telephone: (309) 762-7716
Toll Free: 1-800-872-7720
Fax: (309) 762-9453
Email: [email protected]
Any correspondence must include the following
basic information:
1. The model and serial # of the instrument.
2. Date
purchased.
3. Software version(s) shown on the “Software and
Hardware Information” page.
4. Help system revision. This is displayed by press-
ing the
When calling by phone, it is helpful if the person
is close to the instrument in order to implement
any changes recommended by the Technical Service
Department.
Return for Repair
To return the instrument for repair, please call
the Technical Service Department for shipping
instructions and a RETURN AUTHORIZATION NUM-
BER. This number must be clearly shown on the
outside of the shipping carton in order to expedite
the repair process.
Ship repair to:
Parr Instrument Company
Attn: Service Department
211- 53rd Street
Moline, Illinois 61265